AM.CO.ZA (V6-LABEL/A3) V-Auto A3 Automatic Continuously Sheet Feed (ASF) Label Cutting Machine

1. Click "Engraving Output" to pop up the engraving output screen;

2, click "Settings", the engraving screen will pop up;

3. Click "Compensation Settings" to pop up the dialog box;

4, select "closed compensation", adjust the required value size, you can achieve the ideal

effect, the general set value is 0.5.

Q: Why will there be stroke leakage phenomenon when engraving?

A: 1, check the machine pressure value is appropriate;

2. Reinstall the operating software;

3. Check whether the tool head is flexible;

4, if the problem still exists, please contact the maintenance center.

Q: Why do I cut a deep cut and a shallow cut?

A: Because the cutting machine uses advanced soft PVC material as the pad blade, in order

to protect the carving knife. However, if the use time is too long, the pad will

produce a scratch, so that the pad knife is uneven, and there will be a deep and

shallow phenomenon when the word is cut. At this time, replace the knife bar. In

the case of not serious, the knife can be adjusted according to section 3.2.2, and the

knife pressure can be increased (about 200-300), which can temporarily solve the

problem.

Q: Engraving output, engraving machine does not move what to do?

A: 1, check whether the cutting machine and the computer online is correct; The cutting

machine uses the COM1 or COM2 serial port of the computer to communicate, check

whether the communication port set in the computer is consistent with the

communication port connected to the hardware.

2, check whether the die cutting machine is online.

3, check whether the computer software encryption card is installed, if not, please turn

off the power and reinstall.

4, check the software set cutting machine driver.

- 23－ AM.CO.ZA / Sales WhatsApp 060 600 6000 / Support WhatsApp 060 600 7000

23